Misting Cooling System 98.4FT (30M) Misting Line + 50 Brass Mist Nozzles + 50 T-Connectors + 1 Faucet Adapters (3/4") Outdoor Mister for Patio Garden Greenhouse Trampoline for Waterpark

This misting system is the real MVP of backyard comfort! I picked up several kits and set them up around the house—on the patio and even around the dog run. Now my Rottweiler is chillin’ in style, staying cool and grabbing a drink right at his level. Pretty sure he thinks he has a spa now. At over 98 feet of line and 50 solid brass nozzles, there’s plenty to work with, and it’s super easy to cut and customize to any layout. Install was a breeze with the included T-connectors and faucet adapter, and best of all—it was way cheaper than the big-box stores. Bottom line: If you're looking to beat the heat without busting your wallet, this misting system delivers cool vibes all around—human and canine approved!

I finally installed the mister. The mister heads were easy to install. The hose connector was tight and needed more than reasonable effort (and heat). When I finally got water into the system every mister hose connector leaked. No mist. Water from the mist heads.

Really great value. Installed about 50 feet in an hour in 106 degree weather. Only one nozzle leaked, tightened one quarter turn , fixed, The kit comes with the pictured tubing cutter, use it. When pushing in hose you will feel a little tension at first. Keep pushing, you will feel another area of tension, keep pushing again until the hose will not go any further, Don't crank down on the nozzles when installing them, you will crush the o-ring, Will the nozzles eventually clog? Yes. Look at your faucet aerators and shower heads. Lime and calcium in our water will clog that tiny hole. Just replace them or use a pin with very little pressure to clean them out.

Easy to install but don’t install on an extremely hot day, it softens the hose and they won’t lock in.

Here in Arizona hot is the normal condition, this is a full kit, easy to install, purchased this for a replacement and works great, 4 years and one paint job for removal and I still enjoy it daily and I use it to water my hanging plants also

I used this in my flower beds and set up a timer to water the plants 4 times a day for 10 min. I used 1/4" wire clips. I had to use more than I would have expected to get a full coverage of the area. A few of the nozzles did not work and are likely blocked with debris. The nozzle is very thin so I had to use a very tiny bristle to get in there. After tightening the nozzle to the adapter, some leaked, but all it needed was another 1/4 turn to tighten it down. I used pliers to save my fingers. It has been an extremely hot summer and these were useful to make sure the flowers were watered and healthy, especially when we went on vacation.

An okay enough mister, I suppose? It doesn't really carry high pressure well, tending to disconnect easily at the nodes. At low pressures, the nozzles don't emit mist at all. At medium pressures, the tension of the hoses pulls them from the nodes again. I had to go find extra tools to attach them at too many intervals, because looping them around already erected structures just didn't cut it.

I assembled my kit, turned on the water and ploop, a fitting popped apart, I shoved it back in and another one down the line popped apart, so I went and stuck it back together and pop another one pops.... I got to noticing that this tube that is supplied is super slick on the outside. I went in my tool shed and found some 1/4" air line, it has a satin finish, not shiny and slick... put together a couple of the T fittings and hose adapter with my airline, put full hose pressure to it and BINGO the sprayers work and don't pop apart... "IT'S THE TUBE YA'LL!!!" So I yanked one of the lock/release rings out of a T fitting, slid it onto the supplied black slick tube, squeezed the teeth by hand and it just slid up and down, no grip, just slip..... took that same lock ring and slid it on my 1/4" not shiny tube and when I squeezed the teeth it would slide on, but it didn't wanna slide off, the little teeth were able to grab the surface of the tube.

جيد

Very happy with this product, assembly was straight forward, worse part was finding attachment clips for both wood and edge of a metal purlin, also be aware that if using with bore water or mineral types of ground water, the brass misters block quickly when not used for a few days, due to the mineral build up but usually comes good after some gentle rubbing with your finger or thumb over the tiny hole with the water on.

No me sirvió

جيد

الرذاذ غير كافي و يحتاج مضخه خاصه