EAZ LIFT 48860 Telescopic Jack, (Pack of 2)

Update December 2018: still awesome! Three months in constant use and they're looking great. I HIGHLY RECOMMEND using grease on the threads of these, and any screw jacks. They function much better with grease, including a small bead under the top support pad so the jack post can spin freely under the support pad. Bonus feature: I used four of these to hold my 5th wheel up while I temporarily retracted my landing gear to fix something, too. Worked great! Test would work but I believe in redundancy for safety. As for the top pin setting, these are for support and while they could lift your rv on their own, they're best used just to eliminate bouncing and the top setting will work fine, despite looking wobbly without a load. I wouldn't support anything with ONLY these jacks on the top setting for stability reasons, but they'll be fine providing partial support at maximum height. Original review, September 2018: I'm really happy that I purchased two pairs of these jack stands, they helped a lot with the bounce I was experiencing when walking around or when someone else was walking in the RV. I can even feel the difference between walking around, it feels more solid, like an actual foundation. I have a 35 foot Keystone Montana and replaced the jack stands behind the rear axle and another pair halfway between the front and back of the RV. I've uploaded a video to show what they are like. These looked better than the small aluminum model Camco also makes, and EACH is rated for 6000 lbs. I won't be doing it, but they could theoretically support the entire RV themselves. They do seem a little "loose" at full extension but I see no need to use that top pin setting. The internal screw adjusts a lot. Between these and x-chocks all I want to do is brace my super slide, and remove some sway up above the kingpin, and I'll get a strong arm kit or similar for that.

I bought these jacks for my motorhome to add stability when parked and raised. The top screw portion of the jack is easy to screw in or out and insures perfect fit. The base portion is wide enough to be stable but can be stored in a relatively small space. The base is made from a central steel tube with three tubular legs welded to it. I examined the thickness of the tubing and the welds closely when I received the jacks. This is a known failure point with cheaper jacks. The material is more then adequately thick and while the welds are not a thing of beauty, they are more then functional. I have had my RV in 50+ mph desert winds with these jacks and they did a great job of stabilizing the RV and preventing rocking. I would recommend the jacks sit on something informally flat and stable like jack pads.

Amazing, we live full time in our RV. It is the absolute best thing we have gotten! I highly recommend getting four as it helps the scissor jacks and reduces all sway. Our two large dogs (Golden/Berner) play and we can barely feel any rocking.

I really like these. They are sturdy, stable and of good quality. They allow us to walk around in the motor home at night without waking anyone. I can use one in a low point near the steps and the other at a point that is much higher near the rear opposite corner. The Pin is locking so it doesn't fall out while positioning the jack yet it is easy to put in and take out. The only reason I did not give it 5 stars (a perfect rating) is because the threads must be lubricated with a thick grease to make it easy enough to tighten against the weight of the motor home frame. In addition the pivot area at the top of the screw that turns inside the "cup" on top must also be lubricated otherwise when tightening the cup rotates with the screw and pivots off of the motor home frame. In my opinion, these Jacks are well worth the price. I will probably buy 2 more to add even more stability.

I had my large pop-up camper (sleeps 6, has a/c, toilet, shower, sink, stove) raised about 10 inches to increase clearance and my old aluminum jack stands were no longer tall enough to reach the frame to stabilize the camper. After attempting to build risers and deciding against it, I ordered 2 sets of these stands. They arrived quickly and worked as expected. I was concerned that they would be too wobbly when extended and while the camper does wobble a bit while all set up, it is an acceptable trade-off for the additional clearance. These are very well built, the pins are strong, they adjust easily and the 3-point base should be very stable on a variety of terrains. Would recommend to those looking for taller, stable stands.

I bought these to stabilize our RV. It works wonderfully. The only complaint would be that when the center column is fully extended, it might seem "wobbly". Once you put weight on it, it's no problem. I chose three legs because I'm not looking to lift the RV with these things, just stabilize them. So if I have to put 6000lbs of my 37' RV on one leg, I might just look for another stabilizer. With kids running around, these are life savers. I bought two sets, four legs in total. Easy to use, many adjustable lengths. Note: I must've had close to 6000lbs at one time because I bent the turning rod thinking I had the weight off. So there ya go.

I bought two sets of these Jack's to put under our 35 foot fifth wheel RV to stabilize it at our seasonal campsite. Many others use cinder (cement) bricks. I liked these jacks as they can be easily adjusted if there is any shifting. Others who use blocks have to re-jack their trailer to add or remove shims to change the height. The Jack's are very well made and easy to adjust. There are two holes for quick adjustments for height and then the top is threaded to tighten as required. The improvement was immediate. The placed the jacks in front and behind the tires. This took any bounce out of the RV. Please noted that I used 3 inch thick, 18 in X 18 in cement slabs leveled on a small crushed rock pad to put underneath the jacks. This ensures the jacks will not get pushed into the ground over time. It is equally important to ensure that the top is in full contact with the steel i-beam frame of the trailer. The jacks are very well made, absolutely no concerns that they can take the weight of the trailer. Rated for 6,000 lbs.

They worked as we hoped they would!

I was unsure about how heavy these would be but when I received them found that they were more than adequate I use them to stabilize my slide on a 34 foot camper. They were great! the only thing i found that i don't like is the spinning top doesn't always sit where it's supposed to as you turn the adjustment, but all in all I'm very happy with my purchase.

Bought them to make the back door on my toy hauler. They work perfectly and adjust to any terrain for level and stability. They are also compact to store

No problem recommending this product to anyone