XHF 200 PCS 1/2" White Self Adhesive Cable Zip Tie Mounts Wire Cable Clips Holders Management Anchors Organizer Holders Squares(HS-100)

Great for running small wires. May need to use glue as double stick tape isnt that good.

These are very durable, perfect for managing a 75’ Ethernet cable, adequate size, and adhesion was way better than expected. It is important to note that this adhesive, as with most adhesive of this type, requires firm, even pressure for 10-30 seconds to properly adhere to a surface. When applied properly, these things were so firmly stuck to the wall that we needed to use a zip tie to pry it off the wall. We were honestly astonished to see that the plastic did not break or deform despite the serious amount of strength we needed to pull it off. We were pleasantly surprised to find that it did not pull the paint/vinyl off of any of the surfaces but in single a spot where the paint was already chipping and, even then, it was only a couple specks, it didn’t tear back a strip of paint or anything like that. I did find that this adhesive does not tolerate even the tiniest bit of moisture on the wall, though. (I hadn’t noticed that water had started to condense on the cold wall by the window, but I wiped it down and it worked perfectly.) Perfect for cable management, particularly in our case where we had up to three CAT6 cables in some areas to run long distances together. Tremendous value for the price. 10/10, exactly what we needed.

Exactly what I needed

Very adhesive great sir cleaning up clutter easy to use easy to install

These are excellent - 3m backing on each piece and stick very well. Make sure to clean with alcohol first.

Work great. Used outdoors for lights and decorations. Holding well in cold and rain. Much easier and not damaging than nailing/stapling. Be careful where you stick if you plan to remove. I may take light weight materials with it.

These work great with a dot of super glue...

I have doubts that the backing is legit 3M, could be. But they do stick well. The key to using any type of foam tape though is to make sure the surface is 100% clean. In my case, with a vehicle, I used brake cleaner (chlorinated) to make sure the surface was super clean. They stuck really good for the wire run I was doing up inside a fender. I doubt if they will fall. They actually do seem better than the GB brand I bought at a local hardware store.