SHNITPWR 5V DC Power Supply Adapter 60A 300W AC to DC Converter Transformer 5 Volt 60 Amp LED Driver 110V / 240V AC Input for WS2812B WS2811 WS2813 SK6812 LED Lighting Project CCTV System

Great price fast delivery

Have had this running for a couple of months now. This this is amazing, and provides a ton of power. Everything you could need for a 6m 144/m LED strip. It's been running a few hours a day, with no issues. Also has an adjustable screw to fine tune the voltage. It does require a bit of set-up though. You will need a 2 prong power cord that you can strip back and wire to the unit. So a little bit of electrical knowledge is needed. Nothing a 5 minute google search, and some wire strippers can't fix

Does everything I need it to do for my daughters led arrays

I purchased the 70a 5V supply for a custom LIFePO4 charger that I am building. The hinged plastic terminal guard is super convenient, just note it doesn’t click lock as securely as one might wish, so take care when the unit is plugged into the mains, three sets of output posts are available, allowing parallel wiring and separate branches, which is good as pulling this kind of amperage through screw connections requires some copper cross sectional area! I was able to adjust the voltage to just over 6V on the high side, perfect for my use. I can see a fuse on PCB for the mains input (nice). I haven’t tested it over 15A yet, no noticeable heating and the fan didn’t turn in at that power level. So far I am very pleased.

Good quality and powerful power supply for my new RGB pixel lights. Highly recommended.

I bought this for a WS2812 LED light project and this power supply worked flawlessly. I purchased a new power cable from Lowe's which had the plug on one end and bare wires on the other and had no problems getting it connected. I used some old bell wire (white/red low voltage wire) to wire the power to the middle of the light strand, connecting it with wire caps. The unit has a fan which automatically activates and deactivates based on the unit's temperate.

no power chord. added ac 110 chord, no led indicator when plugged in. zero documentation, even though its pretty basic. no reading on ay of the 3 outputs. Dead on arrival perhaps?

I use this to power a Raspberry Pi 4 cluster. The 10% voltage adjustment is very useful as the voltage drops somewhat under load. I cut off the USB A connector from a cable and attached the red wire to +5V and the black to COM.

Im Gegensatz zu vorher gekauften Netzteilen kann ich das Netzteil mit rund 180 Watt voll belasten. Die Leistung habe ich auf 180 Watt begrenzt. 200 Watt würden vermutlich auch funktionieren, habe ich aber nicht getestet. 1024 LEDs laufen perfekt :)

So far I'm highly impressed with it. I took measurements and happy days. If you look for something to power a few meters of 144/m led stripes this is the one. Please bare in mind, I only had it tested shortly, I can't comment on how long it would last.

While the qaulity of the unit seems okay there is definitely an issue with isolation between VCC and Grd on the 5v rail. They are basically shorted to the together and have only 50ohms between them..... Not good and unusable.

Good

It has been running without any issues even with a set up error....