ADE Crusader RD3-009 Red Dot + Rear Sight Optic Mounting Plate/Adapter for All Glock (Non-Optic Ready) Models & Taurus G3C, TX22 Gen2 – Motion Awake, 6 MOA, Dovetail Mount Base Included, Waterproof

Fits my G3c

Sat crooked on my Taurus G3 TORO. One of the pins on the bottom of the sight was offset slightly and wouldn't fit into my mounting plate. Causing the optic to sit crooked and not level on the slide. Poor quality control. Returned and decided to try another one. The second one red dot glass cracked within 200 rounds. Returned that one also. The power button is located on the front and is halfway covered by your slide. Unless you have one of them mounting plates that slide into your rear iron sight, but if you have an optic cut slide, this thing is stupid hard to turn on and off. Also the adjustment screws "lock screws" were located on the rear of the optic. If you have rear iron sights you won't be able to unlock those "lock screws" to zero in your optic. You'll have to remove your rear irons and then adjust your optic, and then reinstall your rear irons while your red dot is still attached. It's just an all around poor design. Just don't even buy this. I'm telling ya. I tried 2 different dot sights. And both were messed up and didn't work or broke. These might work for airsoft guns. But not a 9mm. Maybe there's some lucky ones that actually work without breaking. But I personally didn't get one. Wasted too much time dealing with returns and refunds when I could of been having fun at the range.

This is a good red dot sight. Adjustment was a little more difficult than my other red dots otherwise i would have given it 5 stars all around. But it costed much less & is accurate. I am very happy with my purchase.

Great red dot for the price! Easy to install, very good quality for the price! Fit my gen 5 Glock 45 very nicely with no issues!!!

Excellent piece for the price so long as you do not bump into or drop weapon. This optic was simplistic and easy to use. Sighting is particularly easy, which is good because mine tended to require adjusting often. Target acquisition was excellent beyond 10 yards. The closer the target, the more difficult it became. In general, shooting competitively becomes more complicated when you have to remember several variables prior to squeezing trigger and you are under time restraints. All in all I would recommend this red dot if you’re on a budget but be advised that the materials used (aluminum) will not hold up to a fall of greater than 3 feet. Most surprisingly was the fact that mine made contact on artificial turf and sustained the damage shown below. Yet I would still purchase this odd item and most likely will to put onto a 9MM Canik I recently purchased and plan to competitively shoot in the future.

Install was quick simple and easy everything needed is included ... feel bad fit was nice ... did not add much weight to the slide , only 90 rounds with it but holding zero so far I'm very happy !

It looks great on my G17 for it’s price. Very easy to install. First red dot. We’ll see how well it holds once I get to the range.

Mount will not fit a Glock model 20. It slides right through with enough room to wiggle it around. I was lucky that local gun shop had the correct mount. Got the red dot mounted and time to sight it in. Shoot once, red dot goes off. Hit button, comes in. Shoot second shot, red dot goes off. This went on for 10 rounds. Mount is junk, red dot cannot take the recoil of the 10mm round. Will try mounting the red dot on a lighter recoiling handgun.