ICT Billet LS 3-Wire Gen 4 MAP Sensor Manifold Absolute Pressure Connector Plug Pigtail LS2 LS3 LS7 LH6 L92 L76 LY2 LY5 LY6 LC9 LFA LH8 LMG L98 L9H L20 L94 LZ1 L99 L96 LC8 L77 WPMAP40

Worked perfect to connect the the Bosh MAP sensor I'm using in my Arduino project. Nice, strong connections.

I ordered the wrong harness for my 4 bar map sensor, but after using a razor to trim off the tabs this harness worked perfectly.Every connector I’ve gotten from ICT has been very high quality.

I used this to adapt my gmpp wiring harness for a gen IV ls3 without any issues. The harness came with an older style plug that didn’t work with the sensor on the engine.

Fit my vehicle perfect, looks and fit exactly like the factory connector, plenty of high quality wire on pigtail to work with.

Perfect fit, long enough leads to make it work in almost any situation.

The gen 4 three wire worked out awesome plugin was nice and tight and it looks good and works great.

Worked great, I had some wires chewed and rewired with this pig tail and works great

Worked great on my 5.3 turbo swap in my short wide.