EasyDriver Shield Stepping Stepper Motor Driver Board V44 A3967 For Arduino
Descripción
- The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3.3V pulse if you solder SJ2 closed on the EasyDriver).
- MS1 and MS2 pins broken out to change microstepping resolution to full, half, quarter and eighth steps (defaults to eighth).
- Compatible with 4, 6, and 8 wire stepper motors of any voltage.
- Adjustable current control from 150mA/phase to 750mA/phase.
- Power supply range from 7V to 30V. The higher the voltage, the higher the torque at high speeds.
Features: Brand new and high quality. The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3.3V pulse if you solder SJ2 closed on the EasyDriver). MS1 and MS2 pins broken out to change microstepping resolution to full, half, quarter and eighth steps (defaults to eighth). Compatible with 4, 6, and 8 wire stepper motors of any voltage. Adjustable current control from 150mA/phase to 750mA/phase. Power supply range from 7V to 30V. The higher the voltage, the higher the torque at high speeds. Size: 4.8cm x 2cm. Note: Do not connect or disconnect a motor while the driver is energized. This will cause permanent damage to the A3967 IC. Package Included: 1 x A3967 Stepping Motor Shield Driver NO Retail Box. Packed Safely in Bubble Bag.
Preguntas comunes
Trustpilot
Hace 3 semanas
Hace 2 semanas
