Tritium Pro Handgun Sight

Very nice sights. I went back and forth on these vs fiber optic or fiber / tritium combo. I got these over the combo because they were half the price. I was concerned that they would be hard to see in the daylight like the stock p-01 sights. However they are easy to see in the light and they glow bright at night. Also they look very similar to stock cz sights, unlike the fiber optic models.

Great sights, easy to install if you have a sight pusher and gunsmith pin pusher. Took maybe 10 mins to install at the most. I thought the front sight would be difficult but once you remove the pin, the old sight pops off from the front, push the new front sight in and put the pin back in and that’s all there is to it.

"CZ 75D Compact PCR & TruGlo Tritium Pro Glow-in-the Dark Night Sights for CZ Pistols / WHITE RING." The packaging had an applied sticker stating these sights are not for the CZ 75D Compact PCR. I beg to differ. I installed them, front & rear, earlier today. I took my time and worked carefully, all told about two hours start to finish. The factory front was relatively easy, drift out the roll pin, knock out the factory front and tap in the TruGlo front. I used a non-marring plastic hammer to remove the old and replace with the TruGlo. Then replace the roll pin. The rear was considerably more effort, but putting the slide in non-marring fittings for my bench vice allowed me to drive out the old rear sight and drive in the TruGlo. Be PATIENT, work carefully, it can be done. I would rate this a job for advanced amateurs who understand tools. Have the correct drift pin punches as well as a starter punch for the roll pin replacing. Absolutely have non marring padded jaws for a bench vice to secure the slide for rear sight removal and install. Mask off the work area around the sights to prevent marring the finish on the slide. AND, watch a youtube video demonstrating the job for your particular model. I will repeat and disagree with the sticker on the packaging: THESE SIGHTS WILL FIT the CZ 75D Compact PCR. BTW, the TruGlo Tritium Pro Glow-in-the dark Night sights are an essential addition to my PCR, wow, they are VISIBLE, indoors and outdoors!

I ordered these sights for my CZ PO1. They were back ordered but shipped on the early end of the window I was given and I was updated when the shipping date changed and when they shipped. I made sure they were approved for the model, and they fit with no issue not only on the firearm but also with no problems in fitting into the kydex Clinger holster I am using. They stand a little taller but are no wider than the original factory sights. My initial impressions are "WOW", what a difference. The original factory sights are not great. they are small and do not lend themselves to quick acquisition and the "glow in the dark" paint is worthless, they would be better blacked out. The bold orange "golf ball" on the TRUGLO front site really grabs the eye by comparison. I raise the firearm and my eyes just gravitate to the front site as they should. As wide as it is, it may block more of the target than the original but not enough to bother me as this is my EDC and its purpose is defense and not targets or longer range pinpoint accuracy. 5" groups at 50' are no issue. The deeper, wider U cut in the rear sight balances out the additional width of the front and assists in the quick acquisition. I did have to sand the bottoms lightly to install but expected that I would. They are solid. I had to more than "tap" the front sight into place and it toughed it out with no damage to the vial. So why only four stars. The orange sight although so much better, could be so much better. I have other sights that are brighter (more dayglow / fluorescent). It could be brighter and should be an easy fix for TRUGLO if they are listening. Also, the exposed surface of the vials on both the front and rear sight is so reflective that they grab light and distort the center of the vials. This is no issue for me as my EDC but if you shoot for competition or want pinpoint accuracy at distance.....I notice it, so I mention it. The Tritium is bright and gets brighter the less light you have to work with. I hope I never need them. Overall thumbs up, I am genuinely happy with my new TRUGLOW sights. they look built to last as I am hopping time will tell. A vast improvement on the original P01 sights and for me worth the cost of the upgrade. I do recommend that you use a sight pusher to install.

I recently bought a CZ75 which by the way is an awesome pistol, but the factory sights were not awesome, they didnt match the quailty of the gun, so after much research and review reading I decided on these TRUGLO pros, very glad I did, the cost compared to a lot of others is low but the quality isnt low by no means, installing them wasnt a bad task either, you need a couple brass punches and a small hammer and after you remove the old ones clean the slots out with some rubbing alcohol and if they feel too tight them some 120 grit sand paper will fix that, all in all dont hesitate buying these, they are well worth the money

Mixed feelings. These are great sights for the brightness and sturdiness construction. But the front sight did not fit 100% perfectly to the cavity of my P10C. So if you planning on buying these, I recommend that you really take it to a gunsmith for a machining / adjustment of the cavity for installation.

Five stars for the seller (spreetail). I initially received sights for the wrong gun. I contacted Amazon and received an email from spreetail within 20 minutes. I then received replacement sights in five days. Five stars for the sights. They are a tremendous improvement over the CZ 75b factory sights. The sights fit perfectly with very little modification.

These are much more visable and accurate than the original sights that came with the CZ P-01. I highly recommend them. I ad these installed by a local gunsmith and it was not expensive at all. These make it easier to be accurate.